Technical Manuals

 

These courses have been taken and received with great response from the students. They are RSES's answer to general knowledge and preparation for RSES certification. If you are being asked or told by your employer to get certified, this is how it's done.

These Technical Manuals are in a set of three. They are 36 chapters long, averaging one chapter per week. It starts in September and ends in May to June. The class is held at Johnstone Supply Classroom, 1015 SE Pine Portland, OR. 97214. The cost is $512.40 for members and $659.40 for non-members. This includes a thick 3-ring binder and various other handouts. The 3 ring binders should be kept in the service van as reference on the job. The books are laid out so as to build on what the previous book has taught.

Thanks to Johnstone Supply for the use of their classroom.



Manual 1    |    Manual 2    |    Manual 3

RSES Technical Institute - Manual 1
36 Lessons


Lesson 1     Introduction to Refrigeration and Air Conditioning
Lesson 2     Basic Physics
Lesson 3     Major Components Functions
Lesson 4     Gas Laws (Part 1)
Lesson 5     Gas Laws (Part 2)
Lesson 6     Pressure / Temperature Relationship (Part 1)
Lesson 7     Pressure / Temperature Relationship (Part 2)
Lesson 8     The Compression Refrigeration Cycle (Part 1)
Lesson 9     The Compression Refrigeration Cycle (Part 2)
Lesson 10   The Compression Refrigeration Cycle (Part 3)

TEST


Lesson 11   Refrigerant Tables
Lesson 12   Refrigerant Properties Characteristics
Lesson 13   Refrigerant Designations
Lesson 14   Safe Practices and Public Relations
Lesson 15   Compressors
Lesson 16   Open-Type Compressors
Lesson 17   Hermetic and Semi-Hermetic Compressors
Lesson 18   Air-Cooled Condensers
Lesson 19   Water-Cooled Condensers

TEST


Lesson 20   Refrigeration Evaporators
Lesson 21   Capillary Tubes
Lesson 22   Thermostatic Expansion Valves (Part 1)
Lesson 23   Thermostatic Expansion Valves (Part 2)
Lesson 24   Oil in Refrigeration Systems
Lesson 25   Recover, Recycle, Reclaim
Lesson 26   Safe Handling of Refrigerants and Cylinders

TEST


Lesson 27   Fundamental Concepts of Electricity
Lesson 28   Fundamental Concepts of Magnetism
Lesson 29   Voltage = EMF = Potential Difference
Lesson 30   Resistors and Resistance
Lesson 31   Conductors
Lesson 32   Power Supplies
Lesson 33   Circuit Protection Devices
Lesson 34   Electricity for the Refrigeration Service Engineer (Part 1)

TEST


Lesson 35   Electricity for the Refrigeration Service Engineer (Part 2)
Lesson 36   Electricity for the Refrigeration Service Engineer (Part 3)
Glossary of Terms

FINAL EXAM

Back to top

RSES Technical Institute - Manual 2
36 Lessons


Lesson 1     Trade Tools
Lesson 2     Refrigeration Systems Accessories
Lesson 3     Desiccants and Driers
Lesson 4     Defrosting Methods
Lesson 5     Refrigeration Systems Controls
Lesson 6     Refrigeration System Piping (Part 1)
Lesson 7     Refrigeration System Piping (Part 2)
Lesson 8     Retrofits and Disposal Requirements
Lesson 9     Compressor Replacement and System Evacuation

TEST


Lesson 10   Motors
Lesson 11   The Electric Motor in Refrigeration
Lesson 12   Capacitors
Lesson 13   Motor Capacitors and Protectors (Part 1)
Lesson 14   Motor Capacitors and Protectors (Part 2)
Lesson 15   Low-Voltage Thermostats
Lesson 16   Relays, Contactors, and Starters
Lesson 17   Test Equipment (Part 1)
Lesson 18   Test Equipment (Part 2)

TEST


Lesson 19   Troubleshooting (Part 1)
Lesson 20   Troubleshooting (Part 2)
Lesson 21   Troubleshooting (Part 3)
Lesson 22   Using Pressure and Enthalpy Diagrams (Part 1)
Lesson 23   Using Pressure and Enthalpy Diagrams (Part 2)
Lesson 24   Moisture in Air
Lesson 25   Calculating Cooling Loads
Lesson 26   Psychrometrics

TEST


Lesson 27   Heat Transfer (Part 1)
Lesson 28   Heat Transfer (Part 2)
Lesson 29   Estimating Heat Loads (Part 1)
Lesson 32   Estimating Heat Loads (Part 2)
Lesson 31   Room Air Conditioners
Lesson 32   Types of Air Conditioning Systems
Lesson 33   Residential Air Conditioning

TEST


Lesson 34   Humidification (Part 1)
Lesson 35   Humidification (Part 2)
Lesson 36   Review of Safety Codes
Glossary of Terms

FINAL EXAM


Back to top

RSES Technical Institute - Manual 3
36 Lessons


Lesson 1     Basic Heat Pump Theory (Part 1)
Lesson 2     Basic Heat Pump Theory (Part 2)
Lesson 3     Water-Source Heat Pumps
Lesson 4     Computer Room Environmental Control
Lesson 5     Economizer Systems (Part 1)
Lesson 6     Economizer Systems (Part 2)
Lesson 7     Fans and Blowers (Part 1)
Lesson 8     Fans and Blowers (Part 2)
Lesson 9     Air Filters and Electrostatic Cleaning

TEST

Lesson 10   Air Distribution (Part 1)
Lesson 11   Air Distribution (Part 2)
Lesson 12   Air Distribution (Part 3)
Lesson 13   Evaporative Condensers and Cooling Towers
Lesson 14   Water Treatment (Part 1)
Lesson 15   Water Treatment (Part 2)
Lesson 16   Closed circuit Water Coolers
Lesson 17   Air-Cooled Condensing Unit Room Requirements
Lesson 18   Heat Transfer Coils
Lesson 19   Multiple Rack Systems

TEST


Lesson 20   Hydronics (Part 1)
Lesson 21   Hydronics (Part 2)
Lesson 22   Hydronics (Part 3)
Lesson 23   Troubleshooting (Part 1)
Lesson 24   Troubleshooting (Part 2)
Lesson 25   Controls Components and Variables
Lesson 26   Types of Control Systems
Lesson 27   Specifications

TEST


Lesson 28   Sensors
Lesson 29   Basic Control Theory
Lesson 30   Air Supply Equipment (Part 1)
Lesson 31   Air Supply Equipment (Part 2)
Lesson 32   Thermostats and Controllers (Part 1)
Lesson 33   Thermostats and Controllers (Part 2)
Lesson 34   Pneumatic Relays

TEST


Lesson 35   Typical Control Applications
Lesson 36   Control System Maintenance
Glossary of Terms

FINAL EXAM


Back to top




RSES Multnomah Chapter

PO Box 6799
Portland, Oregon 97228

(503) 242-1929

© 2003 RSES Multnomah Chapter
 
























 
 
Web design and maintenance by Amy K. Hanson Web & Print Design